Filter
Top Products
90 WinView/32 Manual Version 2.4.M
Rate:
ADC converter rate. Only those rates available for your A/D controller will be
displayed, making it necessary to designate the A/D type first. Select the
maximum speed allowed by the converter. If camera is an PI-MAX with a
Thomson 512 CCD, select FAST. ST-130 owners must confirm that the internal
hardware jumpers of their controller are properly set for the desired speed. See
ST-130 manual for detailed information.
Resolution:
Number of bits. Choices limited by A/D type selection.
Controller Gain:
Set to Gain 3
Bit Adjust:
Set to No Clip
Note:
Not all of these parameters are provided for every controller model. Ignore
parameters that don’t apply to your system. Further note that the ADC tab page
won’t be present if the controller is a V/ICCD or V/ICCD Control Box. Also, there
may be an A/D DT3152 page. If present, disregard it.
➧ Ignore the
ROI
tab page. The Use Full Chip selection on the Main tab page overrides
any ROI settings that may be present.
➧ On the
Data File tab page
, make the following selections.
Auto Increment File Name Enable:
should be OFF.
Overwrite/Append Existing Files:
Select Overwrite (data file will overwrite an
existing file having the same name).
Overwrite Confirmation:
Check this box so that you will be warned that the
specified file name is already in use. If not checked, the old data file will be
overwritten by the new one. No warning is provided.
Data Type AutoSelect:
Should be selected.
Auto-save and prompts:
Select
Don't auto-save or ask to save
. With this
selection, the user won't receive a prompt when a file is closed as a result of
starting a data collection A prompt will still be issued if the user closes the file
explicitly and it has not been saved since being collected.
Use a New Window for each run:
Leave unchecked.