Filter
Top Products
342 WinView/32 Manual Version 2.4.M
Save Sequence Values to File:
When this box is checked, the sequence values will
be saved
on completion of the run
. The values saved are those actually used to take
the data. The file could be recalled later and used for data normalization or other
purposes.
Setup File:
Opens the Sequence Values File dialog box (Figure 302), which enables the
following:
Ask Before Overwriting:
If checked, user will be queried before a new sequence
value file overwrites an existing one. If unchecked, overwriting can occur
without warning.
Notify When File Has Been Saved:
The file is saved at the end of the data-
acquisition run. User will be notified that this has occurred if this box is
checked.
Use Default File Name:
If checked, sequence value file name will be experiment
file name, but with the extension
PDW
. If unchecked, user must enter the name
in the
Name
text box.
Name:
If not using the default name for the sequence value file, enter the file name
in the provided text box. The button at the end of the box opens a browser to
facilitate assigning the file location.
Software Accumulations:
Sets the number of exposures to be taken for each Shot.
Note that the number of Accumulations set here must be the same as the value set on
the Experiment Setup Main tab page for proper operation.
Figure 301.
Pulse
width/delay
sequence list
box.
Figure 302.
Sequence
Values File
dialog box.