Filter
Top Products
78 WinView/32 Manual Version 2.4.M
V/ICCD
Controller/Detector page
Controller Type:
V/ICCD
Note:
V/ICCD Box and V/ICCD are very different selections. If you have the V/ICCD
camera only, without the Control Box, you should select V/ICCD. If you have the
V/ICCD camera
and
the Control Box, then you should select V/ICCD Box, which allows
you to set the Control Box parameters via the Acquisition Menu
Video Focus
Window.
Comm Port:
Set to the computer COM port used to interface to the V/ICCD.
Detector Type:
Select the detector type either NTSC (RS-170) or CCIR.
Frame Grabber:
Select Serial or Data Translation (3152), whichever applies. See
V/ICCD manual for additional information.
Waveform Mode:
For gated operation select Gate. Otherwise select CW.
Readout Mode:
Selects either the Odd or Even video field to be valid.
External Trigger
Enabled:
Enables or disables an external event trigger.
Polarity:
Selects the polarity of the external event trigger.
Control Buttons:
OK
implements the selections from all pages.
Cancel
closes the Hardware Setup
window, leaving the original settings intact.
Help
opens context-sensitive Help.
Figure 60.
V/ICCD
Controller/
Detector
selection.