Filter
Top Products
344 WinView/32 Manual Version 2.4.M
Termination:
In the External trigger mode, the Termination radio buttons allow you to
choose whether the trigger applied to the PTG will see a termination impedance
of
50
or
High
.
Control Buttons:
Download to PTG:
Clicking on this button immediately sends all current dialog
values to the PTG. Selecting
Download to PTG
also changes the name on the
Cancel
button to
Close
, indicating that canceling is no longer an option.
OK:
Click on this button to close the dialog. Selecting this button does
not
automatically program the pulser/timing generator. To program the selected
values into the timing generator you must click on
Download to PTG
.
Cancel:
The
Cancel
button exits the dialog without saving any settings. The pulser
is reprogrammed with the new values when you execute
Download to PTG
.
Selecting
Download to PTG
also changes the name on the
Cancel
button to
Close
, indicating that canceling is no longer an option.
Help:
Click on this button to open the online help for this window.
PTG window
Operation of the PTG Pulser becomes available when you select
Pulsers
from the
Setup menu, followed by clicking on the
PTG
radio button and then click on the
Setup
PTG
button. This opens the PTG window as shown above. Note that pulser support must
be selected when installing the WinView/32 software for PTG control to be available.
The PTG window contains three tab pages and the four buttons that are always present
independent of the selected tab page.
Figure 304.
PTG window.