Chapter 13 Pulser Operation 187
➧ Select
PTG
. Then click on the
Setup Pulser
button. The PTG window (Figure
166) will open. If PTG is grayed out on the
Pulsers
dialog box, PTG support has
not been installed.
➧ Click on the
Comm Port
tab to bring the Comm Port tab page (Figure 167) to the
front.
➧ Make the Port Type selection. Interface selections are described in detail on
page 83.
Figure 166.
PTG window.
Figure 167.
PTG Comm
Port tab page.