Filter
Top Products
296 WinView/32 Manual Version 2.4.M
Parameters
Exposure Time:
The Exposure Time is the amount of time the shutter will open to
collect data. If no shutter is present, the Exposure Time will be the time between
readouts.
# of Images:
This is the number of sequential images the software will collect and
store in a single file. Each image will be digitized and stored, but all images will
be in a single file. A single image may contain data from more than one region
of interest as defined via the ROI Setup tab.
If the Accumulations value is greater than one, each stored image will contain
summed data sets from two or more exposures. The number of separate images
stored will the same as it would be for Accumulations equal one, but the total
number of exposures required would be the product of the # of Images parameter
times the Accumulations value.
Use Full Chip:
Data will be collected from complete chip. ROIs previously defined are
not disturbed and can be accessed by deselecting Use Full Chip.
Use Region of Interest:
Data will be collected from region(s) defined on ROI Setup
Tab. The full chip or the sum of the active region(s) as defined on the ROI tab is
displayed.
Figure 257.
Main tab page;
left, all but
PI-MAX; right,
PI-MAX.