Filter
Top Products
252 WinView/32 Manual Version 2.4.M
Toolbar:
Allows the Data Window toolbar bar to be switched on or off.
Display Layout:
Opens the Display Layout dialog box.
Detector Temperature dialog box
If the selected controller is a MicroMAX, ST-133 or V/ICCD (or control box), clicking
Detector Temperature on the Setup menu will open the Detector Temperature dialog box
(Figure 214), which is used to set the detector temperature with these controller models.
In addition to allowing the user to set the detector temperature, this dialog box indicates
whether temperature lock has been established. If the controller is a V/ICCD or V/ICCD
Control box, it is also possible to set the temperature from the Focus dialog box. See
Temperature Control
on page 86 for additional information.
Parameters
Target Temperature:
Used to set the detector temperature, which can be directly
keyed or set using the spin wheels. The detector isn’t instructed to go to the new
temperature until the Set Temp button is clicked.
Set Temp:
Pressing this button directs the detector to go to the new Target
Temperature.
Current Temperature:
Followed by
Locked
or
Unlocked
to indicate whether
temperature lock has been established. This indication is automatically updated
every two seconds. Alternatively, clicking on the Read Temp button will force
an immediate update.
Read Temp:
Forces an immediate update of the Current Temperature
Locked/Unlocked indication.
Control Buttons:
OK button:
Closes the Detector Temperature dialog box.
Cancel button:
Closes the Detector Temperature dialog box.
Help:
Opens the context sensitive help for the Detector Temperature dialog box.
Figure 214.
Temperature
dialog box.