Filter
Top Products
Chapter 15 Menus and Dialog Boxes 317
Apply Changed Settings
button, which sends only the new parameters to the
PG-200.
OK:
Click on this button to close the dialog. Selecting this button does
not
automatically program the pulser/timing generator. To program the selected
values into the timing generator click on
Apply Changed Settings
or
Apply
All Settings
.
Cancel:
The
Cancel
button exits the dialog without saving any settings. This does
not
mean, however, that the pulser was not reprogrammed. The pulser is
reprogrammed when you click on
Apply Changed Settings
or
Apply All
Settings
. If you do this and then click
Cancel
, the new values will already
have been programmed into the pulser/timing generator.
Help:
Click on this button to open the online help for this window.
PG-200 Continuous Pulsing Setup dialog box
When Continuous pulsing, the Pulse Width and Pulse Delay remain constant at the
values specified. They can be entered directly or you can use the spin wheels to set the
wanted settings. The units are selected from the drop-down boxes to the right of the data-
entry windows.
Control Buttons:
OK:
Enters the specified values and closes the dialog box, returning you to the
PG-200 window. Note that the parameter values aren’t transmitted to the
pulser/timing generator until you select
Apply Changed Settings
(
or
Apply
All Settings
)
and click on OK.
Cancel:
Closes the dialog box leaving the original settings in effect.
Help:
Opens context-sensitive help for the Continuous Pulsing Setup dialog box.
Figure 276.
Continuous
Pulsing setup
dialog box.