Filter
Top Products
346 WinView/32 Manual Version 2.4.M
Control Buttons:
OK:
Executes the selection and closes the dialog box.
Help:
Access context-sensitive help for the Pulsers dialog box.
Pulsing tab page
See:
DG-535 Pulsing tab page:
pg. 256
PG-200 Pulsing tab page:
pg. 318
PTG Pulsing tab page:
pg. 337
Range Display Layout tab page
Sets the region to be displayed and the intensity mapping. If a file contains multiple
frames, allows you to select the frame that will be displayed.
Introduction
Allows you to turn
Initial Autoscaling
On or Off. When On, on opening a file but
before displaying the data, the intensity range is automatically adjusted to a value that
allows the full intensity range of the data to be displayed. Additionally, this page allows
you to manually set the intensity mapping for the displayed data. There is also provision
for selecting
Live Auto All Scans
, in which every scan is auto-scaled. This can be
particularly advantageous when focusing or making other system adjustments with live
data.
If a file contains multiple frames, you can select the frame that will be displayed. You
can also select the X and Y pixel range of the data to be displayed. Note that is not the
same as ROI, which sets the pixel range of the data that will be captured. These and
other features are discussed in the following paragraphs.
Figure 307.
Range display
layout tab
page.