Filter
Top Products
66 WinView/32 Manual Version 2.4.M
PentaMAX
Controller/Detector page
Controller Type:
Select PentaMAX
Controller Version:
Set to match the version of your PentaMAX. Later versions
of the PentaMAX have features unavailable in earlier ones. For proper
operation, version selection must match the actual controller version.
CCD Type:
Select the CCD type installed in your PentaMAX.
Shutter Type:
There are five selections, None, Small, Large, Remote and
Electronic. For most PentaMAX cameras, the correct setting is Small. In the case
of a camera having a very large CCD, such as the Kodak 4k × 4k, a large shutter
may have been installed, in which case the correct setting will be Large. The
Remote setting is primarily intended for spectroscopy applications where an
external shutter would be placed ahead of the entrance slit. Electronic only
applies to operation with an Intensified PentaMAX.
If the PentaMAX has no shutter, select None.
Readout Mode:
The selections are Full Frame, in which the entire chip can be read
out, and Frame Transfer, in which only the unmasked area of the chip can be
read out. Note that frame transfer is only available if the camera has a frame-
transfer chip, such as the EEV 512 × 1024.
Figure 54.
Penta
MAX
Controller/
CCD selection.