Filter
Top Products
74 WinView/32 Manual Version 2.4.M
ST-133
Controller/Detector page
Controller Type:
Select ST133
Controller Version:
Set to match the version of your ST-133. Later versions of the ST-
133 have features unavailable in earlier ones. For proper operation, version
selection must match the actual controller version.
Camera Type:
Select the camera type installed in your system. PI-MAX camera
requires ST-133 controller selection.
Shutter Type:
There are five selections, None, Small, Large, Remote and Electronic.
For most cameras, the correct setting is Small. In the case of a camera having a
very large CCD, such as the Kodak 4k × 4k, a large shutter may have been
installed, in which case the correct setting will be Large. The Remote setting is
primarily intended for spectroscopy applications where an external shutter would
be placed ahead of the entrance slit. Electronic only applies to operation with an
Intensified camera, which would normally not be equipped with a mechanical
shutter. This selection would apply to both the Gate and Shutter/CW modes of
the IIC-100, IIC-200 or MCP-100. If the ST-133 has a frame-transfer chip and
no shutter, select
None
.
Figure 58.
ST-133
Controller/
Camera
selection.