Filter
Top Products
Chapter 3 Hardware Setup 61
Note:
This parameter is not available for all versions of the ST-133
(MicroMAX) Controller. If the
Logic Out
selection doesn’t appear on the tab
page, the selection is done by changing the setting of an internal jumper. The
default selection is SHUTTER MONITOR. Contact factory Tech Support for
information on how to change the jumper setting.
User Defined Chip:
See User Defined Chip discussion on page 80.
User Defined Timing:
See User Defined Timing discussion on page 81.
RS170 Type:
Selections are NTSC (US video standard) and PAL (European).
Display page
See Display tab page discussion on page 82.
Interface page
See the Interface tab page discussion on page 83.
Control Buttons:
OK, Cancel & Help:
These three buttons apply to the Hardware Setup window and are
available for all tab pages. Clicking
OK
implements the selections from all
pages. Clicking
Cancel
closes the Hardware Setup window, leaving the original
settings intact. Help opens context-sensitive help for the active tab page.