Filter
Top Products
326 WinView/32 Manual Version 2.4.M
Control Buttons:
Apply Changed Settings:
Clicking on this button immediately sends any changed
dialog values to the PG-200 Pulser. For example, if the Pulse Width and Trigger
Frequency have been changed since the last time the pulser was programmed,
only those values will be sent to the pulser. This is faster than using the
Apply
All Settings
button, which sends all the PG-200 Setup values to the pulser, and
can take several seconds.
Apply All Settings:
Clicking on this button immediately sends all current dialog
values to the PG-200. Reprogramming of the PG-200 will take several seconds.
If you have only changed one or two dialog items, it is better to click on the
Apply Changed Settings
button, which sends only the new parameters to the
PG-200.
OK:
Click on this button to close the dialog. Selecting this button does
not
automatically
program the pulser/timing generator. To program the selected values into the
timing generator click on
Apply Changed Settings
or
Apply All Settings
.
Cancel:
The
Cancel
button exits the dialog without saving any settings. This does
not
mean, however, that the pulser was not reprogrammed. The pulser is
reprogrammed when you click on
Apply Changed Settings
or
Apply All
Settings
. If you do this and then click
Cancel
, the new values will already
have been programmed into the pulser/timing generator.
Help:
Click on this button to open the online help for this window.
PI Shell Extension
See discussion of
Properties Window
on page 332.
Print dialog box
Figure 284.
Print dialog
box.