Filter
Top Products
256 WinView/32 Manual Version 2.4.M
The Interactive Trigger Setup dialog box, accessed by clicking on the button of the
Custom toolbar, allows you to select the Trigger mode (Internal or External) and, if
Internal is selected, to set the Frequency, all while acquiring data.
Parameters
Trigger Frequency:
The trigger frequency is used with internal triggering. See the
DG-535 manual for valid frequency values.
Trigger Mode radio buttons:
The trigger mode determines whether the timing
generator will create its own trigger signals (
Internal
selected), or will itself be
triggered by trigger signals that originate in an external piece of equipment
(
External
selected). See the DG-535 manual for a description of the external
trigger input on the DG-535.
Control Buttons:
OK:
Click on this button to close the Interactive Trigger Setup dialog box. On
clicking on
OK
, the new parameter values are sent to the timing generator.
Cancel:
The
Cancel
button exits the Trigger Setup dialog box without saving any
settings.
Help:
Click on this button to open the online help for this window.
DG-535 Pulsing tab page
Selects the Continuous or Sequential Pulsing mode and allows access to the setup
screens for Continuous or Sequential Pulsing. Allows bracket pulsing of the PI-MAX
MCP to be switched ON or OFF. See Chapter 13 for additional information on
controlling a pulser/timing generator.
Figure 220.
DG-535
Pulsing tab
page.