Filter
Top Products
182 WinView/32 Manual Version 2.4.M
➧ Make sure the PG-200 is connected to one of the serial ports of the computer. Later
you will tell WinView32 the name of this port (COM1, COM2, etc.). The software
cannot automatically detect the location of the PG-200.
➧ Following the intensifier precautions listed in the hardware manuals, turn on the PG-
200 Pulser and wait for it to initialize. If the PG-200 isn’t turned on, the
WinView/32 software cannot program it.
➧ Select
Setup
, then
Pulsers
, then
PG-200
. Then click on the
Setup PG-200
button to open the PG-200 window (Figure 158). If PG-200 is grayed out on the
Pulsers
dialog box, PG-200 pulser support has not been installed.
➧ Click on the
Comm Port
tab to bring the Comm Port tab page to the front (Figure
159).
Figure 158.
PG-200
window.
Figure 159.
PG-200 Comm
Port tab page.