Filter
Top Products
212 WinView/32 Manual Version 2.4.M
Cancel:
Click on this button to close the Experiment Setup window without making any
changes.
Help:
Opens context-sensitive help for whichever tab page is on top.
ADC tab page
This tab page allows you to make the analog-to-digital (ADC) selections for your
system. If your controller has more than one ADC, you will be able to select FAST or
SLOW. This selection in turn determines the available rate and resolution selections. A
few controllers allow additional ADC parameter control. Note that this page is not
provided for all controllers. Specifically, it is not available if the selected controller is a
V/ICCD, or V/ICCD Controller Box. Also, where the page is provided, not all
parameters will be available for all controller models.
Parameters
Type:
If the controller has two ADCs, you will have the choice of selecting FAST or
SLOW. If you only have one ADC, FAST or SLOW, whichever applies, will be
displayed. Should you attempt to select an uninstalled type, an error message
will be displayed. Note that the type selection determines the available values in
the rate and resolution selection lists. With an PI-MAX camera, selecting FAST
on the A/D page causes the High Capacity preamplifier node to be selected.
Conversely, selecting SLOW on the A/D page causes the Low Noise
preamplifier node to be selected. The node selection is indicated on the Main
page.
Figure 189.
ADC tab page
(Penta
MAX
left and ST-138
right).