Filter
Top Products
Chapter 15 Menus and Dialog Boxes 263
Termination:
In the External trigger mode, the Termination radio buttons allow you to
choose whether the trigger applied to the DG-535 will see a termination
impedance of
50
or
High
.
Control Buttons:
Download to DG-535:
Clicking on this button immediately sends all current
dialog values to the DG-535. Selecting
Download to DG-535
also changes the
name on the
Cancel
button to
Close
, indicating that canceling is no longer an
option.
OK:
Click on this button to close the dialog. Selecting this button does
not
automatically program the pulser/timing generator. To program the selected
values into the timing generator you must click on
Download to DG-535
.
Cancel:
The
Cancel
button exits the dialog without saving any settings. The
pulser is reprogrammed with the new values when you execute
Download to
DG-535
. Selecting
Download to DG-535
also changes the name on the
Cancel
button to
Close
, indicating that canceling is no longer an option.
Help:
Click on this button to open the online help for this window.
DG-535 window
Operation of the DG-535 Pulser becomes available when you select
Pulsers
from the
Setup menu, next click on the
DG-535
radio button and then click on
Setup DG-535
button. This opens the DG-535 window as shown above. Note that pulser support must
be selected when installing the WinView/32 software for DG-535 control to be available.
The DG-535 parameters are set via the IEEE-488 GPIB link between the computer and
the DG-535 Pulser. The choices provided by the tab pages correspond to those provided
by the DG-535 front panel, and are described below and in detail in the DG-535 manual.
The DG-535 window contains three tab pages and the four buttons that are always
present independent of the selected tab page.
Figure 226.
DG-535
window.