Filter
Top Products
262 WinView/32 Manual Version 2.4.M
Software Accumulations:
Sets the number of exposures to be taken for each Shot.
Note that the number of Accumulations set here must be the same as the value set on
the Experiment Setup Main tab page for proper operation.
Control Buttons:
OK:
Saves the specified parameter values and closes the dialog box, returning you to
the DG-535 window.
Cancel:
Closes the dialog box without saving any of the specified values.
Help:
Accesses context-sensitive help for this window.
DG-535 Triggers tab page
The DG-535 Triggers tab page allows selection of the Input Trigger mode, Input or
External, and additionally allows the applicable parameters for the modes to be set.
Parameters
Trigger Frequency:
The trigger frequency is used with internal triggering. See the
DG-535 manual for valid frequency values.
Trigger Mode radio buttons:
The trigger mode determines whether the DG-535 will
create its own trigger signals (
Internal
), or will itself be triggered by trigger
signals that originate in an external piece of equipment (
External
). See the DG-
535 manual for a description of the external trigger input on the DG-535.
Threshold:
In the External trigger mode,
Threshold
sets the required height the
applied trigger must be to trigger the DG-535.
Slope:
In the External trigger mode, the
Slope
radio buttons allow you to choose
whether the DG-535 will be triggered on the positive-going or negative-going
edge of the applied trigger.
Figure 225.
DG-535
Triggers tab
page.