Filter
Top Products
318 WinView/32 Manual Version 2.4.M
PG-200 Pulsing tab page
The Pulsing tab page allows you to set the gate pulse characteristics of the PG-200
Pulser. Through the
Continuous
and
Sequential
setup screens, it allows you to set the
pulse width and the delay between application of a trigger and the time the output pulse
is generated. It additionally allows the output to be enabled or disabled. The associated
control buttons are active for all of the PG-200 tab pages. See Chapter 13 for additional
information.
Parameters
Continuous:
Opens the Continuous Pulsing setup dialog box.
Sequential:
Opens the Sequential Pulsing dialog box.
Enable/Disable radio buttons:
Gating is only possible with
Enabled
selected. Read
all cautions and warnings in the hardware manuals before selecting
Enabled
.
After
Enable
is selected you must click on
Apply Changed Settings
or
Apply All Settings
and click on OK for the change to take effect.
Control Buttons:
Apply Changed Settings:
Clicking on this button immediately sends any
changed dialog values to the PG-200 Pulser. For example, if the Pulse Width and
Trigger Frequency have been changed since the last time the pulser was
programmed, only those values will be sent to the pulser. This is faster than
using the
Apply All Settings
button, which sends all the PG-200 Setup values
to the pulser, and can take several seconds.
Apply All Settings:
Clicking on this button immediately sends all current dialog
values to the PG-200. Reprogramming of the PG-200 will take several seconds.
If you have only changed one or two dialog items, it is better to click on the
Figure 277.
PG-200
Pulsing tab
page.