Filter
Top Products
188 WinView/32 Manual Version 2.4.M
➧ Click on
Initialize Port
. If the software cannot find the PTG to initialize it, you will
get an error message. If this happens, check the cable connections and check that the
Controller is powered.
➧ Click on the
Triggers
tab to bring the Triggers tab page (Figure 168) to the front.
➧ Select the Trigger mode, either
Internal
, in which the PTG free runs, or
External
,
in which it is triggered from an external source.
➧ If operating in the
Internal
trigger mode, set the trigger
Frequency
in Hz. .
➧ If operating in the
External
trigger mode, specify the
Threshold
,
Slope
,
Coupling
and
Impedance
appropriate for the trigger source.
➧ Click on the
Pulsing
tab to bring the Pulsing tab page to the front.
Figure 168.
PTG Triggers
tab page.