Filter
Top Products
308 WinView/32 Manual Version 2.4.M
Parameters tab page (Binning and Skipping)
The Binning and Skipping Parameters tab page allows the bin size to be set
independently in the X and Y directions.
The Skipping parameter sets the interval between bins. The Skipping parameter size can
be independently set for X and Y. Data points that fall in the skip zones do not contribute
to the output. Skip values of zero are allowable, that is, no points will be skipped. Left
over points at the end of a strip or column are discarded.
There is also provision for either averaging or summing the binned data points. If
Average
is selected, each output data value will be the average of the binned data
values in each region. If Average is unselected, each output data value will be the sum of
the binned data values. See Chapter 11 for additional information.
Control Buttons:
Mouse:
Allows you to specify a region to be processed using the mouse. Simply
drag a box in the data region of the active window and then click on
Mouse
.
The
Frame
and
Range
parameters will assume the values of the defined
region. Note that the
Mouse
button is only active when the
Input
tab page is
selected.
Process:
Initiates the process selected via the Parameters tab page. The selected
process is performed on the data specified on the Input tab page and saved using
the file name and data type specified on the Output tab page.
Close:
Closes the window with no action taken.
Help:
Opens context-sensitive help for the active tab page.
Figure 267.
Binning and
Skipping
Parameters tab
page.