Filter
Top Products
2-60 PERIODIC MAINTENANCE
Maintenance Procedure
•
Apply brake fluid to the outside of the piston, and push it
into the cylinder by hand.
•
Replace the shaft rubber friction boot [A] and dust boot
[B].
•
Apply a thin coat of PBC (Poly Butyl Cuprysil) grease to
the caliper holder shafts [C] and holder holes [D] (PBC is
a special high temperature, water-resistance grease).
•
Install the pad spring [A] in the caliper as shown.
•
Install the pads (see Rear Brake Pad Installation in the
Brakes chapter).
•
Wipe up any spilled brake fluid on the caliper with wet
cloth.
Spark Plug Repla cement
•
Remove:
Stick Coils (see Stick Coil (Ignition Coil together with
Spark Plug Cap) Removal in the Electrical System chap-
ter)
•
Remove the spark plug using the 16 mm (0.63 in.) plug
wrench [A] vertically.
Owner’s Tool - Spark Plug Wrench, 16 mm: 92110-1132
•
Replace the spark plug with a new one.
Standard Spark Plug
Type: NGK CR9EIA-9
•
Insert new spark plug in the plug hole, and finger-tighten
it first.
•
Using the plug wrench [A] vertically, tighten the plug.
CAUTION
The insulator of the spark plug may break if when
the wrench is inclined during tightening.
Torque - Spark Plugs: 13 N·m (1.3 kgf·m, 115 in·lb)
•
Install the stick coils securely.
○
Be sure the stick coils are installed by pulling up it lightly.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com