Filter
Top Products
4-14 COOLING SYSTEM
Radiator
If the radiator bracket [A] was removed, install it.
Torque - Radiator Bracket Mounting Bolt [B]: 7.0 N·m (0.71
kgf·m, 62 in·lb)
•
Tighten:
Torq ue - Radiator Lower Bolt [C]: 7.0 N·m (0.71 kgf·m, 62
in·lb)
Radiator Upper Bolt [D]: 7.0 N·m (0.71 kgf·m, 62
in·lb)
Horn [E]
•
Face the white mark [F] of the radiator hose [G] direction
as shown.
•
Install the water hose clamp [H].
Torque - Water Hose Clamp Screw: 2.0 N·m (0.20 kgf·m, 18
in·lb)
•
Run the coolant return hose [I] under the heat insulation
rubber plate and install it.
•
Run the radiator overflow hose [J] over the heat insulation
rubber plate and install it.
•
For the California Model, install the separator [K] and
clamp [L].
Torque - Separator Bracket Mounting Bolt [M]: 7.0 N·m
(0.71 kgf·m, 62 in·lb)
Canister/Separator Hose Clamp Bolt [N]: 7.0 N·m
(0.71 kgf·m, 62 in·lb)
○
Route the canister and separator hoses according to
Cable, Wire, and Hose Routing section in the Appendix
chapter.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com