Filter
Top Products
5-28 ENGINE TOP END
Cylinder Head
Cylinder Head Removal
•
Drain the coolant (see Coolant Change in the Periodic
Maintenance chapter).
•
Remove:
Fuel Tank (see Fuel Tank Removal in the Fuel System
(DFI) chapter)
Air Cleaner Housing (Air Cleaner Housing Removal in
the Fuel System (DFI) chapter)
Throttle Body Assy (see Throttle Body Assy Removal in
the Fuel System (DFI) chapter)
Water Temperature Sensor Lead Connector (see Re-
moval/Installation in the Fuel System (DFI) chapter)
Clutch Cable Lower End (see Cable Removal in the
Clutch chapter)
Front Exhaust Pipe (see Front Exhaust Pipe Removal)
Cylinder Head Cover (see Cylinder Head Cover Re-
moval)
Camshafts (see Camshaft Removal)
•
Remove the front camshaft chain guide bolt (upper) [A].
•
Remove:
Crankshaft Sensor (see Crankshaft Sensor Removal in
the Electrical System chapter)
Starter Clutch (see Starter Clutch Removal in the Elec-
trical System chapter)
Left and Right Front Engine Mounting Bolts (see Engine
Removal in the Engine Removal/Installation chapter)
Front Camshaft Chain Guide Bolt (Lower) [A]
Front Camshaft Chain Guide [B]
•
Loosen the M6 and M10 cylinder head bolts as shown
sequence [1 ∼ 10] in the figure, and remove them.
•
Take off the cylinder head to forward.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com