Filter
Top Products
SUSPENSION 13-25
Swingarm
Swingarm Bearing Removal
•
Remove:
Swingarm (see Swingarm Removal)
Collar [A]
Oil Seals [B]
Sleeve [C]
Circlip (Right Side) [D]
Special Tool - Inside Circlip Pli ers : 570 01-143
•
Remove the ball bearing and needle bearings.
Special Tools - Oil Seal & Bearing Remover [A]: 57001-1058
Bearing Remover Head: 57001-1293
Bearing Remover Shaft: 57001-1377
Swingarm Bearing Installation
•
Replace the ball and needle bearings with new ones.
•
Install the ball and needle bearings so that the m anufac-
turer’s marks face out.
Special Tool - Needle Bearing Driver, 28: 57001-1610
•
Install the needle bearings [A], ball bearing [B] and oil
seals [C] position as shown.
Circlip [D]
32 mm (1.26 in.) [E]
17 mm (0.67 in.) [F]
0.5 mm (0.02 in.) [G]
1 mm (0.04 in.) [H]
10.5 mm (0.41 in.) [I]
28 mm (1.10 in.) [J]
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com