Filter
Top Products
SUSPENSION 13-29
Tie-Rod, Rocker Arm
○
Screw the needle bearing driver [A] into the driver holder
[B].
○
Insert the needle bearing driver into the needle bearing
[C] and press the needle bearing into the housing until
the driver contacts the end surface of the housing.
Bearing’s Pressing Depth: 5.5 mm (0.22 in.) [D]
5.0 mm (0.20 in.) [E]
NOTE
○
For a bearing of inner diameter 18, select the pressing
side of the needle bearing driver according to its press-
ing depth.
Special Tools - Bearing Driver Set: 57001-1129
Needle Bearing Driver,
17/ 18: 57001
-1609
Spacer,
18 [F]: 57001-1636
NOTE
○
Install the needle bearings so that the marked side
faces out.
Needle Bearing [A]
Oil Seals [B]
Front [C]
Right Side [D]
Left Side [E]
Rear Shock Absorber [F]
Tie-Rod [G]
Rocker Arm [ H]
7.5 mm (0.30 in.) [I]
5.0 mm (0.20 in.) [J]
5.5 (0.22 in.) [K]
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com