Filter
Top Products
STEERING 14-13
Handlebar
Handlebar Removal
•
Remove:
Steering Damper (see S teering Damper Removal)
Clutch Lever Clamp Bolts [A]
Clutch Lever Assembly [B]
Left Switch Housing [C]
Handlebar Weight [D]
•
Remove:
Front Brake Reservoir Bracket Nut [A]
Front Brake Master Cylinder [B]
Front Brake Light Switch Connector [C]
Right Switch Housing [D]
Throttle Case [E]
Throttle G rip [F]
Handlebar Weight [G]
•
Loosen:
Front Fork Clamp Bolts [A]
Handlebar Bolts [B]
•
Remove:
Steering Stem Head Nut and Washer [C]
Steering Stem Head [D] with Handlebars [E]
•
Remove:
Handlebar Position Bolts [A]
Handlebars [B]
Left Handlebar Grip
Handlebar Installation
•
Apply adhesive cement to the inside of the left handlebar
grip.
•
Apply a non-permanent locking agent:
Handlebar Position Bolts
Torque - Handlebar Bolts: 25 N·m (2.5 kgf·m, 18 ft·lb)
Handlebar Position Bolts: 9.8 N·m (1.0 kgf·m, 87
in·lb)
•
Install the front brake master cylinder (see Front Master
Cylinder Installation in the Brakes chapter).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com