Filter
Top Products
ENGINE REMOVAL/INSTALLATION 8-5
Engine Removal/Installation
Engine Removal
•
Support the rear part of the swingarm with a stand.
•
Squeeze the brake lever slowly and hold it with a band
[A].
WARNING
Be sure to hold the front brake when removing the
engine, or the motorcycle may fall over. It could
cause an accident and injury.
CAUTION
Be sure to hold the front brake when removing the
engine, or the motorcycle may fall over. The engine
or the motorcycle could be damaged.
•
Drain:
Engine Oil (see Engine Oil Change in the Periodic Main-
tenance chapter)
Coolant (see Coolant Change in the Periodic Mainte-
nance c hapter)
•
Remove:
Middle Fairings (see Middle Fairing Removal in the
Frame c hapter)
Coolant Reserve Tank (see Coolant Reserve Tank Re-
moval in the Cooling System chapter)
Fuel Tank (see Fuel Tank Removal in the Fuel System
(DFI) chapter)
Air Cleaner Housing (see Air Cleaner Housing Removal
in the Fuel System (DFI) chapter)
Throttle Body Assy (see Throttle Body Assy Removal in
the Fuel System (DFI) chapter)
Clutch Cable Lower End (see Cable Removal in the
Clutch chapter)
Radiator (see Radiator and Radiator Fan Removal in the
Cooling System chapter)
Front Exhaust Pipe (see Front Exhaust Pipe Removal in
the Engine Top End chapter)
Shift Lever (see Shift Pedal Removal i n the Crank-
shaft/Transmission chapter)
Engine Sprocket (see Engine Sprocket Removal in the
Final Drive chapter)
•
Pull off the connectors from the engine and free the wiring
from the clamps.
•
Disconnect:
Camshaft Position Sensor Connector [A]
Harness Joint Connector [B]
Immobilizer Amplifier Connector (Immobilizer Models)
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com