Filter
Top Products
3-136 FUEL SYSTEM (DFI)
Fuel Tank
•
Draw the fuel out from the fuel tank with a c ommercially
available pump [A].
○
Use a soft plastic hose [B] as a pump inlet hose in order
to insert the hose smoothly.
○
Put the hose through the fill opening [C] into the tank and
draw the fuel out.
Front [D]
WARNING
The fuel could not be removed completely from the
fuel tank. Be careful for remained fuel spillage.
•
Be sure to place a piece of cloth [A] around the fuel hose
joint.
•
Insert a minus screw driver [B] into the slit [C] on the joint
lock.
•
Turn [A] the driver to disconnect the joint lock [B].
•
Pull [C] the fuel hose joint out [D] of the outlet pipe.
WARNING
Be prepared for fuel spillage; any spilled fuel must
be completely wiped up immediately.
When the fuel hose is disconnected, fuel spills out
from the hose and the pipe because of residual
pressure. Cover the hose connection with a piece
of clean cloth to prevent fuel spillage.
•
Remove:
Fuel Tank Bolt [A]
Drain Hose [B]
•
Close the fuel tank cap.
•
Remove the fuel tank [C], and place a it on a flat surface.
○
Do not apply the load to the outlet pipe of the fuel pump.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com