Filter
Top Products
ELECTRICAL SYSTEM 16-47
Ignition System
2nd Check
•
Start the engine to the following conditions.
Condition:
Transmission Gear → 1s t Position
Clutch Lever → Pulled in
Sidestand → Up
○
Turn the ignition switch ON and push the starter button.
○
Then the starter motor should turn when the starter sys-
tem circuit is normality.
If the starter motor is not turn, inspect the starter lockout
switch, gear position switch, sidestand switch and relay
box.
If their parts are normality replace the ECU.
3rd Check
•
Inspect the engine for its secure stop after the following
operations are completed.
•
Run the engine to the following conditions.
Condition:
Transmission Gear → 1s t Position
Clutch Lever → Release
Sidestand → Up
•
Set the side stand on the ground, then the engine will
stop.
If whichever may not be stopped, inspect the gear position
switch, starter lockout switch, sidestand switch and relay
box.
If their parts are normality, replace the ECU.
IC Igniter I nspection
○
The IC igniter is built in the ECU [A].
•
Refer to the Interlock Operation Inspection, Ignition Sys-
tem Troubleshooting chart and Fuel System (DFI) chap-
ter for ECU Power Supply Inspection (see Interlock Op-
eration Inspection, Ignition System Troubleshooting chart
and Fuel System (DFI) chapter for ECU Power Supply In-
spection).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com