Filter
Top Products
BRAKES 12-17
Master Cylinder
Master Cylinder Inspection (Visual Inspection)
•
Remove the master cylinders (see Front/Rear Master
Cylinder Removal).
•
Disassemble the front and rear master cylinders (see
Master Cylinder Rubber Parts Replacement in the Peri-
odic Maintenance chapter).
•
Check that there are no scratches, rust or pitting on the
inner wall [A] of each master cylinder and on the outside
of each piston [B].
If a master cylinder or piston shows any damage, replace
them.
•
Inspect the primary cup [C] and secondary cup [D].
If a cup is worn, damaged softened (rotted), or swollen,
the piston assembly should be replaced to renew the
cups.
If fluid leakage is noted at the brake lever, the piston as-
sembly should be replaced to renew the cups.
Front Master Cylinder [I]
•
Check the dust covers [E] for damage.
If they are damaged, replace them.
•
Check the piston return spring [F] for any damage.
If the springs are damaged, replace them.
•
Check that relief port [G] and supply port [H] are not
plugged.
If the relief port becomes plugged, the brake pads will
drag on the disc. Blow the ports clean with compressed
air.
Rear Maser Cylinder [J]
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com