Filter
Top Products
5-38 ENGINE TOP END
Throttle Body Assy Holder
Throttle Body Assy Holder Removal
•
Remove:
Fuel Tank (see Fuel Tank Removal in the Fuel System
(DFI) chapter)
Air Cleaner Housing (Air Cleaner Housing Removal in
the Fuel System (DFI) chapter)
Throttle Body Assy (Throttle Body Assy Removal in the
Fuel System (DFI) chapter)
Clamps [A]
•
Loosen the throttle body assy holder bolts as shown se-
quence [1 ∼ 3] in the figure, and remove them.
•
Remove the throttle body assy holders [B].
Throttle Body Assy Holder Installation
•
Be sure to install the new O-rings [A].
•
Apply grease to the new O-ring.
•
Install the clamps [B] as shown.
•
Tighten the holder bolts following the tightening sequence
[1 ∼ 3].
Torque - Throttle Body Assy Holder Bolts [C]: 10 N·m (1.0
kgf·m, 89 in·lb)
Throttle Body Assy Holder Clamp Bolts [D]: 2.0
N·m (0.20 kgf·m, 18 in·lb)
Upside View [E]
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com