Filter
Top Products
6-8 CLU TCH
Clutch Cover
Release Shaft Installation
•
Apply high-temperature grease to the oil seal lips on the
upper ridge of the clutch cover.
•
Apply oil to the needle bearings in the hole of the clutch
cover.
•
Apply molybdenum disulfide grease to the pusher-holding
portion [A] on the release shaft.
•
Install the washer [B] and spring [C].
•
Insert the release shaft straight into the upper hole of the
clutch cover.
CAUTION
When inserting the release shaft, be careful not to
remove the spring of the oil seal.
•
Fit the spring [A] as shown.
Viewed from Rear [B]
Release Shaft [C]
Clutch Cover [D]
•
Install the clutch cover (see Clutch Cover Installation).
Clutch Cover Disassembly
•
Remove:
Clutch Cover (see Clutch Cover Removal)
Release Lever and Shaft Assembly (see Release Shaft
Removal)
Oil Seal [A]
Oil Filler Plug [B]
•
Remove the needle bearings [A].
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com