Filter
Top Products
2-54 PERIODIC MAINTENANCE
Maintenance Procedure
•
Replace the filter with a new one.
•
Apply engine oil to the gasket [A] before installation.
•
Tighten the filter with the oil filter wrench.
Torque - Oil Filter: 31 N·m (3.2 kgf·m, 23 ft·lb)
NOTE
○
Hand tightening of the oil filter can not be allowed since
it does not reach to this tightening torque.
•
Pour in the specified type and amount of oil (see Engine
Oil Change).
Brake Hose and Pipe Replacement
CAUTION
Brake fluid quickly ruins painted plastic surfaces;
any spilled fluid should be completely washed away
immediately.
•
When removing the brake hose, take care not to spill the
brake fluid on the painted or plastic parts.
•
When removing the brake hoses [A], temporarily secure
the end of the brake hose to some high place to keep fluid
loss to a minimum.
•
Immediately wash a way any brake fluid that spills.
•
There are washers on each side of the brake hose fitting.
Replace them with new ones when installing.
•
Tighten:
Torque - Brake Hose Banjo Bolts: 25 N ·m (2.5 kgf·m, 18
ft·lb)
•
When installing the hose [A], avoid sharp bending, kink-
ing, flatting or twisting, and route the hoses according to
Cable, Wire, and Hose Routing section in the Appendix
chapter.
•
Fill the brake line after installing the brake hose (see
Brake Fluid Change).
Brake Fluid Change
NOTE
○
The procedure to change the front brake fluid is as fol-
lows. Changing the rear brake fluid is the same as for
the front brake.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com