Filter
Top Products
16-106 ELECTRICAL SYSTEM
Switches and Sensors
Gear Position Switch Insp ection
NOTE
○
Be sure the transmission mechanism is good condition.
•
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) c hapter).
•
Disconnect the connector [A].
•
Set the hand tester [A] to the 1 kΩ or × 100 Ω range and
connect it to the terminals in the gear position switch lead
connector [B] and ground.
[C] Internal Circuit
[1] Light Green Lead
[2] Green/Red Lead
[3] Black Lead
Special Tool - Hand Tester: 57001-1394
Gear Position Switch Resistance kΩ
Connections
Gear
Position
[1]-Ground [2]-Ground [3]-Ground
Neutral about 0
– –
1st
–
3.00 ∼ 3.32 11.63 ∼ 12.87
2nd
–
1.70 ∼ 1.89 10.33 ∼ 11.44
3rd
–
1.07 ∼ 1.19 9.70 ∼ 10.74
4th
–
0.695 ∼ 0.769 9.32 ∼ 10.32
5th
–
0.430 ∼ 0.476 9.06 ∼ 10.03
6th
–
0.248 ∼ 0.274 8.89 ∼ 9.81
If the tester reading is not as specified, replace the gear
position switch with a new one.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com