Filter
Top Products
ENGINE TOP END 5-19
Camshaft Chain Tensioner
•
Remove the mounting bolts [A] and take off the camshaft
chain tensioner body [B].
Camshaft Chain Tensioner Installation
•
Replace the O-ring [A] with a new one.
•
Apply grease to the new O-ring.
•
Release the stopper [B] and push the push rod [C] into
the interior of tensioner body [D].
•
Install the tensioner body so that the stopper faces up-
ward.
•
Tighten the tensioner mounting bolts [A].
Torque - Camshaft Chain Tensioner Mounting Bolts: 10
N·m (1.0 kgf·m, 89 in·lb)
•
Install:
Rod [B]
Spring [C]
Washer [D]
•
Tighten the cap bolt [E].
Torque - Camshaft Chain Tensioner Cap Bolt: 20 N·m (2.0
kgf·m, 15 ft·lb)
•
Run the radiator hose correctly (see Cable, Wire, and
hose Routing section in the Appendix chapter).
•
Tighten:
Torque - Water Hose Clamp Screw: 2.0 N·m (0.20 kgf·m, 18
in·lb)
•
Fill the radiator with coolant (see Coolant Change in the
Periodic Maintenance chapter).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com