11-10 FINAL DRIVE
Drive Chain
•
After staking, measure the outside diameter [A] of the link
pin and link plates width [B].
Link Pin Outside Diameter
Standard: 5.60 ∼ 5.90 mm (0.22 ∼ 0.23 in.)
Link Plates Outside Width
Standard: 19.70 ∼ 20.00 mm (0.775 ∼ 0.787 in.)
If the reading exceeds the specified length, cut and rejoin
the chain again.
•
Check:
Movement of the Rollers
•
Adjust the drive chain slack after installing the chain (see
Drive Chain Slack Inspection in the Periodic Maintenance
chapter).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com