Filter
Top Products
ELECTRICAL SYSTEM 16-71
Meter, Gauge, Indicator Unit
○
When the terminals are connected, all the LCD segments
[A] appear for three seconds.
If the LCD segments will not appear, replace the meter
assembly.
•
Disconnect the terminal [1].
○
All the LCD segments disappear.
If the segments do not disappear, replace the meter as-
sembly.
MODE AND RESET BUTTON Operation Check
•
Connect the 12 V battery and terminals in the same man-
ner as specified in the "Liquid Crystal Display (LCD) Seg-
ments Check".
•
Check that the display [B] change to the ODO, TRIP, and
CLOCK and STOP WATCH displays each time the MODE
button [A] is pressed.
○
When the fuel level warning indicator light (LED) blinked,
display change to FUEL, ODO, TRIP, CLOCK and, STOP
WATCH and FUEL.
If the display function does not work, replace the meter
assembly.
•
Indicate the clock mode.
•
Check that when the RESET button [A] in CLOCK mode
is pushed for m ore than two seconds, the meter display
turns to the clock s et mode.
○
Both the hour and minute display start flashing.
•
In the HOUR/MINUTE setting mode, press the reset but-
ton [C] again to effect the HOUR setting mode.
○
The hour display flashes on the display.
•
Press the MODE button [A] to set the hour.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com