5-20 ENGINE TOP END
Camshaft, Camshaft Chain
Camshaft Removal
•
Remove the cylinder head cover (see Cylinder Head
Cover Removal).
•
Remove the timing inspection cap [A] and starter clutch
bolt cap [B] on the starter clutch cover [C].
•
Using a wrench on the starter clutch bolt [A], turn the
crankshaft clockwise until the line [B] (TDC mark for #1,4
pistons) on the starter clutch is aligned with the notch [C]
in the edge of the timing inspection hole [D] in the starter
clutch cover.
If the starter clutch cover is removed, perform the next
procedure.
○
Using a wrench on the starter clutch bolt [A], turn the
crankshaft clockwise until the line [B] (TDC mark for #1,4
pistons) on the starter clutch [C] is aligned with the mating
surface [D] of crankcase rear side.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com