Filter
Top Products
13-16 SUSPENSION
Front Fork
•
Set the holder bar [B], and compression shafts [A].
•
Hold the piston rod nut [A].
•
Remove the piston rod puller [B].
•
Install the rebound damping adjuster rod [A].
•
Screw in the top plug [A] stopped onto the piston rod.
•
Check the O-ring [B] on the top plug and replace it with a
new one if damaged.
•
Holding the top plug with a wrench, tighten the piston rod
nut [C] against the top plug.
Torque - Piston Rod Nuts: 15 N·m (1.5 kgf·m, 11 ft·lb)
•
While holding up the fork spring compressor, pull out the
fork spring stopper.
•
Remove the fork spring compressor.
•
Raise the outer tube and screw the top plug into it and
install it to the steering stem.
•
Screw in the spring preload adjuster [A] of the top plug
so that the distance between the adjuster top and the top
plug nut surface is 17 mm (0.67 in.) [B].
•
Turn in the rebound damping adjuster until the fully tight-
ened position and turn backward the 10th click.
•
Install the front fork (see Front Fork Installation).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com