Filter
Top Products
12-14 BRAKES
Brake Pads
Rear Brake Pad Removal
•
Remove the caliper with the hose installed.
•
Remove:
Clip [A]
Pad Pin [B]
Brake Pads [C]
Rear Brake Pad Installation
•
Push the caliper piston in by hand as far as it will go.
•
Install the pad spring in place.
•
Install the piston side pad [A] first, and then another pad.
○
Fit the projections [B] of the pad into the recesses [C] of
the caliper holder.
•
Install the pad pin and clip. The clip must be “outside” of
the pads.
•
Install the caliper (see Caliper Installation).
WARNING
Do not attempt to drive the motorcycle until a full
brake pedal is obtained by pumping the brake pedal
until the pads are against the disc. The brake w ill
not function on the first application of the pedal if
this is not done.
Brake Pad Wear Inspection
•
Refer to the Brake Pad Wear Inspection in the Periodic
Maintenance chapter (see Brake Pad Wear Inspection in
the Periodic Maintenance chapter).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com