Filter
Top Products
ELECTRICAL SYSTEM 16-103
Switches and Sensors
•
Remove the fuel pump (see Fuel Pump Removal in the
Fuel System (DFI) chapter).
•
Connect the test light (12 V 3.4 W bulb in a socket with
leads) and the 12 V battery to the fuel pump connector as
shown.
12 V Battery [A]
Test Light [B]
Fuel Pump Connector [C]
Fuel Reserve Switch [D]
If the test light doesn’t light, replace the fuel pump.
NOTE
○
It may take a long time to turn on the test light in case
that the fuel reserve switch is inspected just after the
fuel pump is removed. Leave the fuel reserve switch
with leads for inspection connected for few minutes.
Oxygen Sensor Removal (Europe Models)
NOTE
○
The oxygen sensor itself is the same for #1 [A] and #2
[B], but wiring of the main harness side is different.
•
Remove the left m iddle fairing (see Middle Fairing Re-
moval in the Frame c hapter).
•
Disconnect:
Oxygen Sensor #1 Lead Connector [A]
Oxygen Sensor #2 Lead Connector [B]
•
Remove the oxygen sensor #1 [A].
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com