Filter
Top Products
16-104 ELECTRICAL SYSTEM
Switches and Sensors
•
Remove:
Front Exhaust Pipe (see Front Exhaust Pipe Removal in
the Engine Top End chapter)
Oxygen Sensor #2 [A]
Oxygen Sensor Installation (Europe Models)
CAUTION
Never drop the oxygen sensor [A], especially on a
hard surface. Such a shock to the unit can damage
it. Do not touch the sensing part [B] to prevent oil
contact. Oil contamination from hands can reduce
sensor performance.
•
Tighten:
Torque - Oxygen Sensors: 25 N·m (2.5 kgf·m, 18 ft·lb)
•
Run the oxygen sensor leads correctly (see Cable, Wire,
and Hose Routing section in the Appendix chapter).
Oxygen Sensor Inspection (Europe Models)
•
Refer to the Oxygen Sensor #1/#2 Inspection in the Fuel
System (DFI) chapter (see Oxygen Sensor #1/#2 Inspec-
tion in the Fuel System (DFI) chapter).
Oxygen Sensor Heater Inspection (Europe
Models)
•
Refer to the Oxygen Sensor Heater Inspection in the Fuel
System (DFI) chapter (see Oxygen Sensor Heater In-
spection in the Fuel System (DFI) chapter).
Gear Position Switch Removal
•
Remove the lower fairings (see Lower Fairing Removal in
the Frame chapter).
•
Slide out the rubber boot [A].
•
Loosen the oil pressure switch terminal bolt [B], and re-
movetheswitchlead[C].
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com