Filter
Top Products
ELECTRICAL SYSTEM 16-51
Electric Starter System
Starter Clutch Removal
•
Remove:
Starter Clutch Cover (see Idle Gear Removal)
Idle Gear (Starter Clutch Side, see Idle Gear Removal)
•
Unscrew the starter clutch bot [A], while holding the al-
ternator rotor steady with the rotor holder (see Alternator
Rotor Removal).
Special Tools - Grip: 57001-1591
Rotor Holder (Stopper, M38 × 1.5): 57001
-1658
Rotor Holder: 57001-1666
•
Remove the washer [B].
•
Pull the starter clutch gear [A] out of the starter clutch [B].
•
Remove:
Needle Bearing [C]
Starter Clutch
Starter Clutch Installation
•
Install the starter clutch [A] while fitting the alignment
notch [B] of the splines onto the alignment tooth [C].
•
Apply molybdenum disulfide oil solution to the needle
bearing [A], and install it.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com