Filter
Top Products
ELECTRICAL SYSTEM 16-65
Lighting System
•
Insert the new bulb [A] by aligning its upper and lower pins
[B] with the upper and lower grooves [C] in the socket, and
turn the bulb clockwise.
○
Turn the bulb about 15° degrees.
•
Fit the projections [A] of the lens into the grooves [B] of
the turn signal light.
•
Tighten:
Torque - Rear Turn Signal Light Lens Screws: 1.2 N·m (0.12
kgf·m , 11 in·lb)
Turn Signal Relay Inspection
•
Remove:
Seat Cover (see Seat Cover Removal in the Frame
chapter)
Turn Signal Relay [A]
•
Disconnect the connector [B].
•
Connect one 12 V battery and turn signal lights as indi-
cated in the figure, and count how may times the lights
flash for one minute.
Turn Signal Relay [A]
Turn Signal Lights [B]
12 V Battery [C]
If the lights do not flash as specified, replace the turn sig-
nal relay.
Testing Turn Signal Relay
Load
The Number of Turn
Signal Lights
Wattage (W)
Flashing Times
(c/m*)
1**
21 or 23 140-250
2 42 or 46 75-95
*: Cycle(s) per minute
**: Correspond to “one light burned out”
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com