Filter
Top Products
11-12 FINAL DRIVE
Sprocket, Coupling
•
Install the guide [A] into the sprocket cover [B] so that the
hook [C] of the guide fits into the receiver [D].
•
Install the engine sprocket cover [A] with the guide [B].
○
Install the pins [C] into the holes [D].
•
Tighten the engine sprocket cover bolts.
Torque - Engine Sprocket Cover Bolts: 10 N·m (1.0 kgf·m,
89 in·lb)
•
Install the removed parts (see appropriate chapters).
Rear Sprocket Removal
•
Remove the rear wheel (see Rear Wheel Removal in the
Wheels/Tires chapter).
CAUTION
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the w heel so that the disc does
not touch the ground.
•
Remove the rear sprocket nuts [A].
•
Remove the rear sprocket [B].
Rear Sprocket Installation
•
Install the sprocket facing the tooth number marking [A]
outward.
•
Tighten the rear sprocket nuts.
Torque - Rear Sprocket Nuts: 59 N·m (6.0 kgf·m, 44 ft·lb)
•
Install the rear wheel (see Rear Wheel Installation in the
Wheels/Tires chapter).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com