Filter
Top Products
ELECTRICAL SYSTEM 16-111
Fuse
•
Pull the ECU fuse [A] straight out of the fuse box with
needle n ose pliers.
Fuse Installation
If a fuse fails during operation, inspect the electrical sys-
tem to determine the cause, and then replace it with a
new fuse of proper amperage.
•
Install the junction box fuses on the original position as
specified on the lid.
Fuse Inspection
•
Remove the fuse (see Fuse Removal).
•
Inspect the fuse element.
If it is blown out, replace the fuse. Before replacing a
blown fuse, always check the amperage in the affected
circuit. If the amperage is equal to or greater than the
fuse rating, check the wiring and related components for
a s hort circuit.
Housing [A]
Fuse Element [B]
Terminals [C]
Blown Element [D]
NOTE
○
If a mass current flows to the battery which needs re-
freshing charge when the engine is turned, the main
fuse may be blown out.
CAUTION
When replacing a fuse, be sure the new fuse
matches the specified fuse rating for that circuit.
Installation of a fuse with a higher rating may cause
damage to wiring and components.
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com