6-12 CLUTCH
Clutch
Clutch Installation
•
Install the spacer [A] s o that the circle mark [B] faces out-
ward.
•
Engage the clutch housing gear [A] and oil pump drive
gear [B] with the crankshaft primary gear [C] and oil pump
gear [D].
•
Install:
Needle Bearing [A]
Sleeve [B]
○
Apply engine oil to the sleeve and needle bearing.
•
Install the spacer [C] so that the stepped side [D] faces
outward.
If the sub clutch hub bolts was removed, install it.
○
Apply a non-permanent locking agent to the threads of
the sub clutch hub bolts, and tighten it.
Torque - Sub Clutch Hub Bolts: 25 N·m (2.5 kgf·m, 18 ft·lb)
•
Install the clutch hub [A] on the crankshaft.
•
Align the damper cam [B] of the sub clutch hub [C] to the
cam followers [D] of the clutch hub.
•
Install the four torque limiter springs [A] as shown.
○
First Torque Limiter Spring
Tang [B]
