Filter
Top Products
FINAL DRIVE 11-11
Sprocket, Coupling
Engine Sprocket Re moval
•
Remove:
Lower Fairings (see Lower Fairing Removal in the Frame
chapter)
Shift Lever Bolt [A]
•
Pull the shift lever [B].
•
Remove:
Engine Sprocket Cover Bolts [A]
Engine Sprocket Cover [B]
•
Flatten out the bended washer [A].
•
Remove the engine sprocket nut [B] and washer.
NOTE
○
When loosening the engine sprocket nut, hold the rear
brake on.
•
Raise the rear wheel off the ground.
•
Remove the axle cotter pin, and loosen the rear axle nut.
•
Loosen the both chain adjuster locknut to loosen the drive
chain.
•
Remove the drive chain from the rear sprocket toward the
right.
•
Pull the engine sprocket [A] with drive chain [B] off the
output shaft [C].
•
Disengage the drive chain from the engine sprocket.
Engine Sprocket Installation
•
Replace the sprocket washer and axle cotter pin.
•
Install the engine sprocket onto the shaft.
•
Apply molybdenum disulfide oil solution to the threads of
the output shaft and the seating surface of the engine
sprocket nut.
•
After torquing the engine sprocket nut, bend [A] the one
side of the washer over the nut.
NOTE
○
Tighten the nut while applying the rear brake.
Torque - Engine Sprocket Nut: 125 N·m (12.7 kgf·m, 92 ft·lb)
•
Adjust the drive chain slack after installing the sprocket
(see Drive Chain Slack Adjustment in the Periodic Main-
tenance c hapter).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com