Filter
Top Products
ENGINE TOP END 5-47
Muffler
CAUTION
To keep the correct exhaust butterfly valve position,
adjust the open cable first.
•
Install the close cable (green) [A].
•
Install the open cable (yellow) [B] and adjust the adjuster
[C] until the c learance of part [D] of figure come to 0 mm
(0 in.).
CAUTION
Do not overstretch.
•
Tighten:
Torque - Exhaust Butterfly Valve Cable Adjuster Locknut:
7.0 N·m (0.70 kgf·m, 62 in ·lb)
•
Adjust the adjuster [E] of the close cable until the clear-
ance of part [D] of figure come to 0 mm (0 in.).
•
After the adjust, return the locknut to the half from one
rotation.
•
Tighten:
Torque - Exhaust Butterfly Valve Cable Adjuster Locknut:
7.0 N·m (0.70 kgf·m, 62 in ·lb)
•
Cover the dust covers as shown.
10 mm (0.39 in.) or less [F]
15 mm (0.59 in.) or less [G]
•
Install the clamp [H]
•
Apply a non-permanent locking agent to the threads of
the lower cover bolts, and tighten it.
•
Install the other removed parts (see appropriate chap-
ters).
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com
www.zxforums.com